Kenwood TM-G707 Bedienungsanleitung PDF herunterladen (Seite 53)

Note:

◆

Skip steps 3 to 5 if you have already programmed the appropriate

CTCSS frequency.

◆

You can select a separate tone frequency for the CTCSS and Tone

functions.

◆

You cannot use the CTCSS and Tone functions simultaneously.

◆

If you select a high tone frequency, receiving audio or noise that

contains the same frequency portions may cause CTCSS to function

incorrectly. To prevent noise from causing this problem, select an

appropriate noise squelch level {page 15}.

Note:

Use Nos. 01 to 38, shown in the table above, when selecting tone

frequencies via Keypad Direct Entry {page 55} (U.S.A./ Canada only).

■ Automatic Tone Frequency ID

This function automatically identifies the incoming

tone frequency on a received signal.

1 Select the desired band.

2 Press

[TONE] (1 s)

to activate the function.

• The current tone frequency appears and the 1 Hz

decimal blinks.

• When a signal is received, the transceiver begins

scanning through all tone frequencies in order to

identify the incoming tone frequency.

• When the tone frequency is identified, the identified

frequency appears and blinks.

• The identified frequency is programmed in place of

the currently set CTCSS frequency.

3 Press any key to quit the function.

Note:

Received signals are audible while scanning is in progress.

1 s

.oN

.qerF

)zH(

.oN

.qerF

)zH(

.oN

.qerF

)zH(

.oN

.qerF

)zH(

100.76114.79125.631138.291

209.17210.001223.141235.302

304.47315.301322.641337.012

400.77412.701424.151431.812

507.97519.011527.651537.522

605.28618.411622.261636.332

704.58718.811729.761738.142

805.88810.321828.371833.052

905.19913.721929.971

018.49028.131032.681

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 83 84

Kommentare zu diesen Handbüchern

Keine Kommentare

Kenwood TM-G707 Bedienungsanleitung Seite 53

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Radio Stationen Kenwood TM-G707