Kenwood TM-281E Bedienungsanleitung PDF herunterladen (Seite 52)

SCAN RESUME METHOD

The transceiver stops scanning at the frequency (or

Memory Channel) where a signal is detected. It then

continues or stops scanning according to which Resume

Mode you have selected.

• Time-Operated Mode (default)

The transceiver remains on a busy frequency (or

Memory Channel) for approximately 5 seconds, then

continues to scan even if the signal is still present.

• Carrier-Operated Mode

The transceiver remains on a busy frequency (or

Memory Channel) until the signal drops out. There is

a 2-second delay between signal dropout and scan

resumption.

• Seek Mode

The transceiver moves to a frequency (or Memory

Channel) where a signal is present and stops.

To change the scan resume method:

Press

[F]

[MENU]

and turn the

Tuning

control to

select Menu No. 13 (SCAN).

Press

[MENU]

and turn the

Tuning

control to

select “TO” (Time-Operated; default), “CO” (Carrier-

Operated), or “SE” (Seek) Mode.

Press

[MENU]

to store the new setting or any other

key to cancel.

Press any key other than

[MENU]

to exit Menu Mode.

Note:

To temporarily stop scanning and monitor weak signals, press

the Mic PF key assigned the MONI function {page 59}. Press the

MONI key again to resume scanning.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 80 81

Keine Kommentare

Kenwood TM-281E Bedienungsanleitung Seite 52