Kenwood th-k20a Bedienungsanleitung PDF herunterladen (Seite 58)

VOX GAIN

To enjoy the VOX function, take the time to properly adjust the VOX Gain level.

This level controls the VOX circuit to detect the presence or absence of your

voice.

There are 2 ways to adjust the VOX Gain.

While the VOX function is ON:

1 Speak into the headset microphone using your normal tone of voice to

transmit.

• If transmitting does not begin, readjust the VOX Gain so that the transceiver

transmits while you are speaking. To readjust the gain, press and hold [PTT] then

rotate the ENC control to select a more sensitive gain level.

• While readjusting the gain, you can release [PTT]. The transceiver will remain in

Adjustment Mode for approximately 5 seconds.

2 Adjust the VOX Gain by rotating the ENC control until the transceiver reliably

switches to transmit mode each time you speak.

From the Menu:

1 Enter Menu mode and access Menu No. 16 (VOX), then press [F].

2 Rotate the ENC control to select the desired VOX gain level from 1 (least

sensitive) to 9 (most sensitive), then press [F] to store the setting.

3 Press [MENU] or [PTT] to exit Menu mode.

VOX ON BUSY

You can configure the transceiver to force VOX to transmit even if the transceiver

is receiving a signal.

1 Enter Menu mode and access Menu No. 17 (VOX.BSY), then press [F].

2 Rotate the ENC control to select “ON”, then press [F] to store the setting.

3 Press [MENU] or [PTT] to exit Menu mode.

Note: You can press [PTT] or [PF] (if 1750 Hz is programmed) to transmit, regardless of the

setting in Menu No. 17.

VOX DELAY TIME

If the transceiver returns to receive mode too quickly after you stop speaking, the

end of your signal may not be transmitted. To avoid this, select an appropriate

delay time that allows your entire signal to be transmitted, before Transmit mode

ends. However, do not make the delay overly long.

1 Enter Menu mode and access Menu No. 18 (VOX.DLY), then press [F].

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 67 68

Keine Kommentare

Kenwood th-k20a Bedienungsanleitung Seite 58