Kenwood VR-5900 Bedienungsanleitung PDF herunterladen (Seite 113)

105

Troubleshooting

Receiver/Tuner

3. Touch . Every time you select the button the volume will cycle

between 0dB, -3dB, -6dB and back up to 0dB.

4. While the source component is playing, reduce the Input Level to -

3dB. If the CLIP indicator still flashes frequently or remains lit for 1

second or longer, reduce the Input Level again to -6dB.

5. Touch

to return to the Setup menu.

I can’t access any RDS (Radio Data System) functions (for U.K. only)

• Confirm that the radio station is broadcasting RDS.

• Make sure you use the Auto Memory function to store RDS stations in

memory. See “Storing RDS Stations Automatically” on page 41 of the

Connections and Setup Guide.

I can’t receive a radio station

Check that:

• The appropriate antenna is connected. See Chapter One of the Con-

nections and Setup Guide.

• The broadcast band is correct. See “Tuner” on page 57 of this manual.

• The tuner is set to the correct frequency. See “Tuner” on page 57 of

this manual.

I’m getting a lot of static/interference

• Check whether the receiver or antenna is too close to a TV or other

electrical appliance.

• Adjust the antenna for best reception.

• If you live in an area with weak FM signals, consider a rooftop or an

amplified FM antenna (available at any home electronics store).

When I press a button to tune to a preset station, the receiver does

not respond

Check whether:

• The receiver has been unplugged for more than three days. If it has,

your settings were cleared from the receiver’s memory. See “My re-

ceiver won’t turn on and the STANDBY indicator is flashing” on

page 103 of this manual.

• The Tuner input is selected. See “Tuner” on page 57 of this manual.

1 2 ... 108 109 110 111 112 113 114 115 116 117 118

Keine Kommentare

Kenwood VR-5900 Bedienungsanleitung Seite 113