Kenwood KRF-V7771D Bedienungsanleitung PDF herunterladen (Seite 14)

KRF-V7771D (En/T)

Setup

PHONES

INPUT SELECTOR

VOLUME

MPEG Cinema Re-EQ

DOLBY DIGITAL

CLIP INDICATOR

POWER

ON/STANDBY

SPEAKERS

MUTE

DOWN

DISPLAY MODE

S VIDEO

AUDIO

CD2 / TAPE2

MONITOR

OFF

AV AUX

2 3 7

54 6 @ # %$ &^

ST.ST.

TUNEDTUNED

MUTEMUTE

Standby mode

1 POWER key

Press to switch the main power ON and OFF.

2 ON/STANDBY ( )key

Press to switch the power mode between

STANDBY and ON.

3 Standby indicator

Lights in standby mode.

4 Remote sensor

Receives signals transmitted from the re-

mote control unit.

5 PHONES jack

Use for listening to audio through headphones.

6 SPEAKERS keys

Press each key to switch the SPEAKERS A or

SPEAKERS B ON and OFF.

7 Indicators

CLIP INDICATOR :

Lights when the input is clipped during

analog to digital signal conversion.

DOLBY DIGITAL :

Lights when Dolby Digital is activated.

Stereo indicator

MUTE indicator

TUNED indicator

Multi-mode display

While the standby indicator of the unit is lit, a small amount of current is flowing into the unit’s internal circuitry to back up the memory. This

condition is referred to as the standby mode of the unit. While the unit is in the standby mode, it can be turned ON from the remote control unit.

Controls and indicators

Display

MPEG :

Lights when the MPEG is activated.

Cinema Re-EQ :

Lights when the Re-EQ is activated.

8 MUTE key

Press to mute the audio temporarily.

9 Remote transmitter

Sends signals to the remote control unit.

0 Communication indicator

Lights when signal is input from or output to

the remote control unit.

! VOLUME control knob

Rotate to adjust the volume.

@ S VIDEO input jack (AV AUX)

Connect the S VIDEO output jack of an AV

component.

# VIDEO input jack (AV AUX)

Connect the composite video output (RCA)

jack of an AV component.

$ AUDIO (L, R) input jacks (AV AUX)

Connect the audio output (RCA) jacks of an AV

component.

% CD2/TAPE2 MONITOR indicator

Lights when the CD2/Tape2 (Monitor) input is

used.

^ DISPLAY MODE key

Press to switch the display on the receiver.

•

Press for more than 2 seconds to switch the

recording mode.

& INPUT SELECTOR key

Press to switch the input as shown below.

TUNER

CD1

MD/Tape1

VIDEO1

VIDEO2

VIDEO3

VIDEO4

AV AUX

PHONO

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 55 56

Kommentare zu diesen Handbüchern

Keine Kommentare

Kenwood KRF-V7771D Bedienungsanleitung Seite 14

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Empfänger und Verstärker Kenwood KRF-V7771D