PROGRAM SCAN
This type of scan is similar to VFO Scan except the
programmable aspect allows you to set scan limits to limit
the frequency range of the scan.
■ Setting Scan Limits
1 Press [F]+ POWER ON to access Menu B.
2 Select “PGM.SCN” {page 17}.
3 Press [VFO],
• “LO" and the current lower limit appears. The default
is the currently selected frequency.
MENU,
I U C O C “
I I I
_____
f
MHz
----
>
-------
OVER
TONE
REV
Turn the Tuning control, or press microphone
[UP]/[DWN], to display the desired lower limit.
• Press [MHz] if you want to change the frequency in
1 MHz steps.
Press [VFO].
• “UP" and the current upper limit appears. The default
is the currently selected frequency.
6 Turn the Tuning control, or press microphone
[UP]/[DWN], to display the desired upper limit.
• Press [MHz] if you want to change the frequency in
1 MHz steps.
7 Press [VFO] to set the upper limit.
8 Press [F] or microphone [PTT] to exit Menu B.
Note:
♦ The lower limit must be lower in frequency than the upper limit.
♦ The lower and upper frequency steps must be equal.
♦ Selections must be made within approximately 10 seconds or the
previous mode is restored.
Confirming Scan Limits
1 Press [F]+ POWER ON to access Menu B.
2 Select “PGM.SCN” (page 17).
3 Press [VFO].
• This is the lower limit.
4 Press [VFO] again.
• This is the upper limit.
5 Press [F] or microphone [PTT] to exit Menu B.
34
Kommentare zu diesen Handbüchern