Kenwood TM-V71E Bedienungsanleitung PDF herunterladen (Seite 59)

CTCSS FREQUENCY ID

This function scans through all CTCSS frequencies to identify the incoming

CTCSS frequency on a received signal. You may find this useful when you

cannot recall the CTCSS frequency that the other persons in your group are

using.

1 Press [TONE] 2 times to activate the CTCSS function.

• The icon appears on the display when the CTCSS function is ON.

• Each press of

[TONE] changes the selection as follows:

Tone (T) –> CTCSS (CT) –> DCS (DCS) –> Off (no display).

2 Press [F], [TONE] (1s).

• The icon blinks and “SCAN” appears on the display.

• Scan starts when a signal is received.

• To reverse the scan direction, turn the Tuning control clockwise (upward scan) or

counterclockwise (downward scan). You can also press microphone [UP]/ [DWN].

• To quit the scan, press

[F] (ESC).

• When a CTCSS frequency is identified, the identified frequency appears on the

display and blinks.

3 Press the Tuning control to program the identified frequency in place of the

currently set CTCSS frequency.

• The CTCSS function will remain ON. To cancel CTCSS, press [TONE] until CT no

longer appears on the display.

• Press

[F] (ESC) if you do not want to program the identified frequency.

• Rotate the

Tuning control while an identified frequency is blinking, to resume

scanning.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 106 107

Keine Kommentare

Kenwood TM-V71E Bedienungsanleitung Seite 59